Finally our first day of decent weather, and the boys finished off the second side of the roof.
We still have to turn up the end of the sheets at the top, and put in some kind of bushfire protection under the ridge cap when we put that on to seal the gaps, but it's looking pretty amazing.
Thursday, 4 January 2018
Monday, 1 January 2018
Roof
Significant
progress has been made on the roof during the christmas holidays, due
to the wonderful help of visiting family. Thanks so much guys!
Since
the last post I spent several mornings putting up the 10 fascia
brackets. First one end, then the other, then a string-line between
them to make sure all the ones in the middle are in a straight line.
I
found this a difficult and annoying job as the brackets tended to
move while I was trying to drill the screws in, despite the clamp
holding it in place. I learned as I went though, and the later
brackets were done much more quickly than the first.
After
this was done, the boys put up the first gutter which was a bit
tricky as it bends very easily. Some supports were taped to it and
then it was lifted up with rope and the use of two ladders. The
gutter is attached with the use of suspension clips and gutter
straps.
Then
the boys put the fascia board on. This was done in two halves with
the middle joined by an extra support piece, riveted together, the
same as the fascia board on the other side of the house. Then the
gutter was put up using the same method as the first side with
supports and ropes.
Next
the roof was started. First the insulation was cut to length and
taped into place, and then a roof sheet was placed over the top and
screwed in. The same was repeated for the other side.
Also
the roof strapping was tensioned up while working up in the roof.
Here you can see the underneath with the roof strapping, the
insulation which is 135cm wide, and two sheets of Colorbond – each
84cm wide.
Subscribe to:
Posts (Atom)